After it hardened, I sanded it down

Helping an Abused Trolling Motor

cheap white jordan shoes I was set to go pick it up for the advertised price (a good bargain) when the woman PMd me that cheap jordans in china her husband had charged the battery and the motor “didn’t work” so he would sell the cheap jordans free shipping battery for $25 and give me the motor free! Since the battery is worth $22 as a core trade in, I agreed cheap white jordan shoes

cheap jordans authentic Once I got them home, I found that the battery cheap jordans china was holding Cheap jordans a good charge so no worries there, but the motor shaft was horribly cheap Air max shoes scarred and the tilt mechanism was bent cheap air force and unworkable. Upon hooking up the motor to the battery, it worked very well smooth Cheap jordans and steady and powerful. I suspect he was ashamed of the mechanical condition of the shaft and tilt. There is supposed to be a plastic piece (a friction strip, according to the manual) inserted in the rectangular notch under the screw to cheap jordans online bear against the shaft. It was missing! The screw had been bearing against the aluminum shaft and scoring it badly. cheap jordans shoes The first time I put my hand on the shaft, it came away with little shards of aluminum stuck in the skin took cheap yeezys a while, some tweezers and magnifier to get them out. cheap jordans authentic

cheap jordans nz The first thing I did was take some 120 grit sandpaper to the shaft. This smoothed out the shaft, cheap nike shoes and removed the bits of metal making cheap jordans on sale it easier to handle. Then I measured the slot to figure how big to make a friction strip. cheap jordans nz

cheap jordan 7 Then I measured the shaft and found it to be 1″ diameter. AHA! Would a cheap jordan sneakers piece cheap jordans sale of 1″ PVC cheap air jordan pipe work? cheap jordan 7

cheap nike jordans uk Turns out it would. The actual friction strip has a molded knob on the top side to prevent it slipping out of the slot when the screw is loosened for adjustments so I cut a small piece, mixed some two part epoxy and stuck it on (ENTRY FOR THESTICK IT!CONTEST!) cheap nike jordans uk

real jordans for cheap prices I painted the friction strip fluorescent orange so I can always be sure it is there. Then I cut another small piece and made a knob for the lower end and glued it on with cyanoacrylate glue (Super Glue). So I mixed another batch of two part epoxy a different kind with better wear characteristics BUT another reason for you to vote for me in the STICK IT! Contest and slathered it in the grooves. Then I took a piece of 1″ cheap jordans from china PVC and ran it along the shaft, removing the excess epoxy. After it hardened, I sanded it down. To be honest, it is poorly designed and weak. real jordans for cheap prices

cheap jordans 2015 In this case, the pin was badly bent, and the lower casting to guide the pin had broken away. topjordanscity.com I think a gorilla tried to change the cheap jordans for sale tilt without pushing on the pin. cheap jordans 2015

cheap jordan 4 shoes I used a vise and channel lock pliers to get the pin decently straight but in the process of disassembly I lost the snap ring that retains the spring. cheap jordan 4 shoes

cheap real jordans mens I found some.032″ stainless steel wire and a washer to fit the pin so I set about drilling a.045″ hole in the pin to hold the wire. That is one SMALL drill but it worked. I started the hole with a center drill and plenty of OIL. Then I went to the.045″ drill and again used plenty of OIL to keep the drill cool and flush away the chips cheap real jordans mens.

Leave a Reply

Your email address will not be published. Required fields are marked *